Eusso UOW2000 Series Manual de usuario descargar pdf (Pagina 13)

2.4.3 Set Operating Mode, IP Address, Subnet Mask, Default

Route IP, DNS Server IP of UOW2000 SERIES

► LAN Settings

These are the settings of the LAN (Local Area Network) interface for the

Access Point. The Access Point's local network (LAN) settings are

configured based on the IP Address and Subnet Mask assigned in this

section. The IP address is also used to access this Web-based

management interface. This option is available in the “/BASIC/LAN/”

page as shown in Figure 2-7.

Figure 2-7

► Get LAN IP From

Choose "DHCP (Dynamic)" if your router supports DHCP and you want

the router to assign an IP address to the AP. In this case, you do not need

to fill in the following fields. Choose "Static IP (Manual)" if your router

does not support DHCP or if for any other reason you need to assign a

fixed address to the AP. In this case, you must also configure the

following fields.

Note that you cannot choose "DHCP (Dynamic)" if you have enabled the

"DHCP Server" option on the DHCP page; the AP cannot be both a DHCP

client and a DHCP server.

► IP Address

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 62 63

Sin comentarios

Eusso UOW2000 Series Manual de usuario Pagina 13